Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Retrofit Screen Panel in Polyurethane for Decks Running Rubber or Wire
Replacing the media on an old deck is rarely a straight swap. The frame has been drilled for one fixing pattern, the support rails have worn unevenly, and the deck width was set by a machine that stopped being built twenty years ago. The usual result is a panel that fits the aperture spec and not the frame.
We work from the frame, not from a catalogue size.
Fixing positions taken from your frame. Send a drawing or a measured sketch with pin centres, rail spacing and the panel outline, and the pin positions are moulded to that geometry. Nothing is drilled on site, no adapter plates, no cutting a panel down on the walkway and losing the sealed edge in the process.
Non-standard sizes are the normal case. Decks converted from rubber commonly sit between standard panel sizes. Because every panel is cut and moulded to a drawing, a 1,180 mm deck or a 1,340 mm deck costs the same to specify as a round number. There is no premium for the size not being in a price list.
Weight and handling. A polyurethane panel at the same thickness is lighter than the rubber panel it replaces, which matters on decks where panels are changed by hand from a walkway. On a retrofit, that is often the difference between a two-man job and a one-man job.
Sealed edges, cut at the factory. Cutting a panel on site exposes the reinforcement and gives slurry a path into the frame. Every panel leaves the factory cut to final size with the edge sealed, so a retrofit does not turn into a corrosion problem six months later.
Where it runs
Decks converted from rubber or woven wire in coal handling, aggregate plants, mineral processing and dewatering sections. It suits older machines where drawings exist but standard panel sizes do not match, and plants that cannot afford a frame rebuild to change media type.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send the frame drawing if you have it. If not, send a measured sketch with pin centres, rail spacing, panel count and deck width. We return a dimensioned drawing for approval; the first panel off the tool is checked against that drawing before the batch runs.
FAQ
What is your MOQ and lead time?
MOQ is 10 pcs. Standard lead time is 15 days, and standard mold making takes 10 days.
What if I do not have a drawing of the old deck?
A measured sketch works. Pin centre to pin centre, rail spacing, panel outline and panel count per deck are enough. If the frame is badly worn, measure the rails as well — a 5 mm rail step changes how the panel seats.
Can I mix panel thickness on one deck?
Yes, and on a converted deck it is often worth doing. Feed end at 40 mm, middle and discharge at 25–30 mm keeps the impact protection where it is needed and takes weight and cost out of the rest of the deck.