Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Coal Washing Screen Panel in Polyurethane for Dense Medium and Drain Decks
In a coal washing plant, the screen deck decides the economics of the circuit. Magnetite that passes through with the correct medium is a cost you pay every shift; magnetite that leaves with the product is a cost you pay twice — once to buy it, and again downstream.
The panel's job is to drain fast and hold the aperture it was specified at.
Slots aligned with the flow. Aperture orientation matters more on a drain deck than aperture size. Slots are moulded parallel to travel so the water film releases through the panel instead of being dragged across it. On a correctly oriented deck, medium drains in the first third of the panel and the rest does separation work.
Tapered profile resists pegging. Coal at drain-and-rinse duty sits right on the boundary of the slot size, which is exactly the size range that pegs. The tapered slot opens through the panel thickness, so a particle that enters does not wedge halfway and hold the aperture shut for the rest of the shift.
Abrasion resistance that holds the slot. The failure mode on a washing deck is not a broken panel, it is a slot that has worn from 0.5 mm to 0.9 mm over a few months, at which point magnetite losses climb and nobody can see why. A wear grade compound at ≤40 mm³ DIN abrasion keeps the slot within specification for the campaign.
Stays fixed under continuous vibration. Washing decks run continuously at high amplitude. A panel that works loose leaks oversize into the correct medium and blocks the sieve bends downstream. Pin and sleeve fixing carries that load through the panel body, so the fixing stays tight between change-outs.
Where it runs
Dense medium drain and rinse decks, correct medium recovery screens, desliming and dewatering sections, and product sizing decks. It suits circuits where magnetite consumption is watched and a slot drifting out of specification shows up in the cost per tonne washed.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck drawing, medium-to-coal ratio, cut point and the magnetite consumption you are currently seeing per tonne. If losses are the reason for the enquiry, tell us the slot size currently in service — worn slots are the most common cause and the cheapest to fix.
FAQ
What is your MOQ and lead time?
MOQ is 10 pcs. Standard lead time is 15 days, and standard mold making takes 10 days.
Which slot size should I run on a drain deck?
It depends on the medium size split, but most drain-and-rinse decks sit between 0.5 mm and 1.0 mm. Send the medium specification and we will match the slot to it rather than to a rule of thumb.
Will polyurethane handle the magnetite abrasion better than rubber?
On this duty the advantage is not hardness, it is slot stability. Polyurethane holds a moulded slot dimension far better than rubber, which is what keeps medium losses from creeping up between campaigns.