Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Wide Deck Screen Panel in Polyurethane for Spans up to 3.6 m
Wide decks are where tensioned panels get exposed. A panel spanning 1.8 m or more deflects in the middle under its own weight and the bed load, and once it starts to drum it works against the fixing instead of with it. The failure shows up as a slack panel, then a cracked panel, then a deck that will not hold its cut.
Span support designed with the panel. Panels for wide decks are specified with the support rail layout, not independently of it. Where a deck has a centre rail, the panel is moulded to seat on it; where it does not, we size the section and the land width so that deflection under the working bed depth stays within a range the material can take.
Rail clamp fixing spreads the load. On spans over about 2.4 m, a rail clamp distributes the fixing load continuously along the panel edge instead of concentrating it at pins. That keeps the edge sealed and stops the panel creeping along the rail as the deck vibrates.
Mass kept under control. Deflection is a function of span, section stiffness and weight. A 40 mm panel on a light support layout can be heavier than the deck wants; where impact is not the governing case, 25–30 mm sections bring the mass down and the natural frequency up, which is what stops the drumming.
Replacement without dismantling the deck. Wide decks are the worst case for a panel change because the panel is large and there is nowhere to stand. Fixing positions matched to the existing rails mean panels are lifted and seated from above, one at a time, without removing cross members.
Where it runs
Wide sizing and scalping decks in aggregate plants, coal preparation screens over 2.4 m wide, mineral processing screens with centre support rails, and dewatering decks on large fixed plants.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send the deck drawing with rail positions and centre support layout, plus the panel count across the width. Width, span and support spacing determine the section we recommend; we return a dimensioned drawing before production.