Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Mobile Screen Panel in Polyurethane for Track-Mounted and Portable Plants
A mobile plant does not get maintained the way a fixed plant does. It works for six weeks on one site, gets moved, and starts again with whatever condition the deck was left in. Panels that need a crane, a torque wrench and half a shift to change do not get changed on a mobile plant — they get run until they fail.
Change-out with a mallet, not a tool kit. Pin and sleeve fixing means a panel is lifted out and seated back without bolting. On a tracked plant working a temporary site, that is the difference between a 20-minute job between loads and a job that waits for the next scheduled stop.
Weight the deck structure can carry. Mobile screens are built light because the whole plant has to travel. A 25–30 mm polyurethane section in the sizing and discharge zones keeps the panel mass down without giving up wear life, and keeps the deck within the design load.
Handles the impact of a primary-fed deck. On a two-deck mobile plant the top deck takes material straight from the crusher, which means lump impact and uneven feed from a loader bucket. A 40 mm section at the feed end with wide lands absorbs that without cracking.
Slots that survive high-moisture feed. Mobile plants working sand pits and demolition material often run damp feed with no chance to adjust the water. Tapered slots and panel flex keep the surface open when the material is sticky, which is where square-hole rubber panels lose capacity fastest.
Where it runs
Track-mounted jaw and cone plants, portable wash plants, contractor-owned screening units and rental fleets working aggregate, C&D material and sand pits.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send the machine model and deck drawing, or the panel outline with fixing centres. For fleets running several machine models, tell us the mix — panels for a common fixing pattern can be specified so that one spare set covers more than one unit.