Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Sticky Feed Screen Panel in Polyurethane for High-Moisture, High-Clay Duty
Sticky feed does not wear a panel out. It shuts it down. Clay and wet fines bridge across apertures, the open area falls shift by shift, and the deck that was rated at 250 tph is running at 150 tph with the same amps on the motor. Operators respond by washing the deck, which adds water and makes the next shift worse.
Tapered slot geometry does the work. Every aperture widens through the panel thickness. A particle that enters at the top face has a clear path out at the bottom face, so it does not wedge at mid-depth and hold the hole shut. This is the single detail that separates a panel which stays open from one that blinds by mid-shift.
Panel flex breaks the bridge. A 25–40 mm polyurethane section deflects under the vibrating deck and returns, and that movement is what releases near-size particles sitting across an aperture. Rigid media — steel plate, heavy rubber — do not flex, so the bridge stays until someone hits it with a bar.
Land width balanced against open area. Wide lands resist wear but reduce open area; narrow lands open the deck up but wear through faster. On sticky duty the balance is different from dry screening: open area matters more, because a blinded deck has zero capacity regardless of how thick the panel is.
Surface that does not grip wet fines. Polyurethane releases wet material more readily than rubber, which is why the same aperture will run longer on this compound in a high-clay circuit.
Where it runs
Sand pits with clay seams, demolition and excavation material, wet coal fines, bauxite and iron ore with high moisture, and any deck where blinding rather than breakage limits throughput.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send feed moisture, clay content, gradation and current aperture. We will propose a slot layout — including whether to open the feed-end aperture — rather than simply matching the size you run now.