Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Metal Ore Screen Panel in Polyurethane for Abrasive, High-Density Duty
Ore is not sand. It is heavier, sharper and often hotter than the aggregate duty most screening media is designed around. A panel that performs well on gravel can be cut through in weeks on iron ore, and the failure is usually not a hole — it is a worn land between apertures that lets oversize through and quietly changes the product.
Wear compound, not just a hard compound. Abrasion resistance in polyurethane comes from the elastomer's ability to recover rather than from hardness alone. A harder compound that cannot recover cracks under impact; a compound with rebound resilience at or above 40 % absorbs the energy and returns it, which is what a high-density ore duty needs.
Reinforcement around the fixing. On ore decks, failure often starts at the fixing where the panel is locally stressed. Reinforcement positioned in the fixing zone carries the load into the panel body, so the fixing outlasts the wear surface instead of the other way round.
Tapered slots for wet grinding circuits. Ore screening is usually wet, and near-size particles at the cut point are exactly the ones that peg. A slot that opens through the thickness releases them, which keeps the circulating load where the mill was designed to run it.
Thickness graded by deck position. Feed end at 40 mm for lump impact; middle and discharge at 25–30 mm where the bed is thinner and the wear is sliding rather than impacting. Grading the deck this way usually costs less than running one heavy section throughout.
Where it runs
Iron ore scalping and sizing, copper and gold milling circuits, heavy mineral sands, chromite and manganese ore, and dewatering of concentrate ahead of stockpile or filtration.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send ore type, bulk density, feed size, cut point, moisture and screen motion. On ore duty we also ask for the current wear life in weeks — it is the fastest way to tell whether the compound or the section is the limiting factor.