Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Rubber has one real advantage on a screen deck: it absorbs impact. Everything else it does, polyurethane usually does better — it holds an aperture, it does not swell in water, it releases wet fines, and it weighs less. The reason plants stay on rubber is rarely performance. It is that changing media type sounds like a project.
Same fixing, no frame work. Panel outline and fixing positions are moulded to your existing frame, so a rubber-to-polyurethane change is a panel swap, not a deck rebuild. Pin centres, rail spacing and panel count stay as they are.
Aperture that stays where it was moulded. Rubber apertures deform under load and wear open; a slot specified at 10 mm becomes 12 mm over a campaign, and the product changes with it. A moulded polyurethane slot holds its dimension, which is what keeps a specification saleable over the full panel life.
No swelling in wet duty. Rubber absorbs water and softens over time in continuous wet service. Polyurethane is a hydrolysis-resistant grade here, so a panel that has been on a wash deck for six months behaves the same as it did in week one.
Lighter, so panels get changed. A polyurethane panel at the same thickness weighs less than the rubber it replaces. On decks where panels are lifted by hand, that changes how often inspection actually happens — and inspection is what prevents a worn panel from becoming a contamination complaint.
Where it runsWash plants, coal handling, aggregate sizing, dewatering sections and ore dressing decks currently running rubber media, where the aim is longer aperture life and less blinding without a capital project.
Technical data|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Send the rubber panel you run now — outline, thickness, aperture and fixing centres — and we will quote the polyurethane equivalent with the same fixing geometry, plus a note on where a thinner section would work.