Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Fine Slot Screen Panel in Polyurethane for Tailings and Fines Recovery
Below about 2 mm, a screen deck stops separating and starts filtering, and every decision changes. Open area falls, the bed holds water, and a slot that is 0.1 mm out of tolerance is a product that is out of specification. Fine slot panels are the hardest thing to get right on a tailings deck for exactly this reason.
Slots moulded, not cut. A machined tool produces every slot to the same width, so the last slot on a panel matches the first. On a 1.0 mm cut point, that consistency is what makes the deck's performance predictable from one panel to the next.
Taper through the thickness. Each slot widens from the top face to the bottom face, so a near-size particle releases on the return stroke instead of wedging. On tailings duty, where the feed is at the cut point by definition, this is the difference between a working deck and a deck that is cleaned twice a shift.
Thin section, high open area. Fine duty runs at 15–25 mm rather than 40 mm, because open area matters more than impact resistance when the feed is slurry. A thinner section also flexes more, which helps release particles.
Weight that one person can handle. Fine panels are the ones changed most often, because that is where wear and blinding concentrate. Keeping the section light means a fitter can lift a panel out alone, inspect it and put it back without a crane.
Where it runs
Tailings dewatering and recovery, fine coal and mineral fines, sand plant effluent, carbon-in-leach circuit screens and industrial effluent polishing.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send cut point, feed solids content, deck dimensions and screen motion. For fine duty we also need the particle size distribution — it decides whether a slot panel is the right tool or whether the cut is better made another way.