Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Steel Frame Polyurethane Screen Panel for High Load and Long Span Decks
Plain polyurethane has one weakness on a heavy deck: it is elastic. Under a deep bed and repeated impact the panel deflects, and the deflection has to go somewhere. It goes into the fixing, the bolt hole elongates, the panel shifts, and the aperture layout you paid to have moulded starts moving relative to the frame.
A steel frame inside the panel takes that load instead.
Steel encapsulated in polyurethane. The frame is a welded steel structure fully enclosed in the cast body, bonded during moulding rather than inserted afterwards. Load paths from the deck, the impact zone and the fixing all pass through the steel and into the frame — the polyurethane is left to do the job it is good at, which is resisting abrasion and holding an aperture.
No bolt-hole elongation. This is the most common failure on wide or heavily loaded decks. With the load carried by an insert rather than by cast material around a hole, the fixing stays round and the panel stays where it was set for the whole service life.
Flat, and stays flat. A frame panel holds its plane across a span. That keeps the working surface in contact with the support rails, stops the panel drumming against the frame, and keeps the aperture geometry consistent from the feed end to the discharge end.
Thick section where the load is. 40 mm at the feed end, reduced to 25–30 mm where the bed thins. Because the frame carries the structural load, the polyurethane section can be sized for wear rather than for stiffness — which is how a deck gets lighter without getting weaker.
Where it runs
Primary and secondary screening decks, feed ends of heavy-duty screens, wide decks with centre support, scalping duties after a primary crusher, and any deck where a plain panel has failed by working loose rather than by wearing out.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck drawing, panel count, screen motion, feed size and drop height at the feed end. Drop height tells us more about the frame specification than tonnage does; we return a dimensioned drawing before production.
FAQ
What is your MOQ and lead time?
MOQ is 10 pcs. Standard lead time is 15 days, and standard mold making takes 10 days.
Does the steel frame corrode?
The frame is fully encapsulated during moulding, so process water does not reach it. Exposed ends at fixing points are sealed. Panels cut on site lose that seal, which is one reason we cut everything at the factory.
Is a frame panel heavier than a plain panel?
Yes, by roughly 15–25 % at the same thickness. On decks where panels are handled by crane or two fitters this is not an issue; on hand-changed decks we sometimes specify a thinner section to keep the weight workable.