Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Coarse Screen Panel in Polyurethane for 50-100 mm Lump Screening
At coarse apertures the engineering problem flips. Open area is no longer the constraint — a 60 mm aperture on a 40 mm panel is already wide open. What limits life is the land between apertures, and whether it can survive a lump landing on it edge-on.
Land width sized for the lump. At 50–100 mm apertures the land is the structure. We size it against the maximum lump size and the drop height rather than against open area targets, because a broken land is a contamination path, not a capacity issue.
Tapered apertures still matter. Even at coarse sizes, a tapered hole releases wedged material. On sticky or wet coarse feed — clay-bound overburden, wet demolition rubble — that is what keeps the deck from carrying a layer of near-size material into the next section.
Frame resists the twisting load. A large-aperture panel is effectively a grid, and a grid twists. Under an uneven bed the panel tries to rack, which is what cracks lands at the corners. An encapsulated frame holds the grid square.
Runs at 40–60 mm section without excessive weight. Coarse panels are large and awkward to handle. A frame panel at 40 mm gives the stiffness of a much thicker plain panel at a fraction of the mass. That matters on a coarse deck, where panels are large, awkward and usually lifted by hand rather than by crane.
Where it runs
Primary scalping at 50–100 mm, run-of-mine screening, overburden and waste separation, demolition rubble sizing and coarse aggregate classification ahead of a secondary crusher.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send maximum lump size, feed rate, cut point and deck drawing. For coarse duty we also ask whether the deck sees run-of-mine material directly from a tip or loader, since that changes the impact case more than the tonnage does.