Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Scalping Screen Panel in Polyurethane for Duty After the Primary Crusher
Scalping is the least forgiving screening job on a plant. The feed comes straight from a jaw or gyratory, it is coarse, it is sharp, and it arrives in surges rather than at a steady rate. Everything downstream depends on this deck doing its job — if the scalping screen blinds or breaks, the secondary crusher gets flooded and the whole circuit slows down.
Built for surge loading. A scalper sees the peak, not the average. Panels are specified with the frame carrying structural load so that a surge of coarse rock does not deflect the deck into the support rails or work the fixings loose.
Sharp edges, not round particles. Crushed rock has edges, and edges cut. A compound with tear strength at or above 80 kN/m resists the cutting action that opens up a slot or splits a land, which is the dominant wear mechanism on scalping duty.
Aperture that holds the cut. The scalping cut point sets the load on the secondary crusher. If the aperture wears open by 5 mm over a campaign, the secondary gets more fines it did not need and the circuit loses capacity. A moulded polyurethane aperture holds its dimension far longer than rubber or punched plate.
Section sized by drop height. Feed-end rows at 40 mm, downstream at 25–30 mm. On most scalpers this reduces total panel mass by a third against an all-40 mm deck, with no loss of life where the bed is thin.
Where it runs
Scalping ahead of secondary and tertiary crushers, run-of-mine screening at the pit, C&D material ahead of a jaw, and slag or clinker handling where the feed is coarse and hot-material risk is absent.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send crusher setting (CSS), maximum lump size, feed rate, deck drawing and drop height. The CSS and the scalping cut point have to be consistent; if they are not, we will flag it before quoting.