Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Quarry Screen Panel in Polyurethane for Hard Rock and Abrasive Aggregate
Quarry Screen Panel | Steel Frame Polyurethane
A hard rock quarry runs one material and runs it hard. Granite, basalt and quartzite are sharp, abrasive and consistent, which sounds easier than mixed feed — and it is, until you look at what consistent abrasion does to a deck over twelve months. The panel does not fail suddenly. It wears open, quietly, until the specification drifts and a customer notices.
Abrasion resistance measured, not claimed. DIN 53516 abrasion at or below 40 mm³ is the number that matters on quarry duty, and it should be available as a test report rather than a brochure line. Ask for it and compare it against what you are running now.
Aperture stability over the campaign. The commercial value of a quarry panel is not just how long it lasts, it is whether the last tonne screened meets the same specification as the first. A moulded polyurethane aperture holds its width; punched plate wears its holes oval and rubber deforms under load.
Frame for multi-deck machines. Quarry screens are usually two or three decks on one shaft, and the lower decks inherit the load path from above. A steel frame keeps each panel flat and independent, so a worn top deck does not distort the panels below it.
Thickness graded by deck and position. Top deck at 40 mm, bottom decks at 25–30 mm, feed-end row heavier than the discharge row. On a three-deck quarry screen this is where most of the cost saving sits.
Where it runs
Primary, secondary and tertiary sizing in hard rock quarries, manufactured sand production, asphalt aggregate grading, rail ballast sizing and riprap classification.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck drawing for each deck, rock type, feed gradation, cut points and current panel life in weeks. If you have a specification for the finished product, send that too — the aperture is chosen against it, not against the nominal size.