Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
High Capacity Screen Panel in Polyurethane for Deep Bed, High Tonnage Decks
Capacity is not a property of a panel. It is the result of open area, bed depth, stroke and the time the material spends on the deck. Change one and the others move. What a panel can do is give you the open area without giving up the flatness that keeps the bed moving — and that combination is what separates a 400 tph deck from a 300 tph deck of the same width.
Open area without a flexible deck. The obvious way to raise open area is thinner lands and a thinner section, which makes the panel flexible and lets it drum. A steel frame keeps the panel flat at open areas that a plain section could not hold, so capacity comes from geometry rather than from giving up structure.
Bed depth controlled by the aperture layout. On a deep-bed deck the material stratifies as it travels. A slightly coarser aperture on the first section drops the fines early and keeps the bed thin where the water is, which raises throughput without changing the cut point of the finished product.
Width without a dead zone. On decks over 2.4 m, the middle of a wide panel is where the bed runs deepest and where a sagging panel loses contact with the material. The frame holds the plane, so the whole width does screening work instead of only the edges.
Stroke and acceleration matched to the panel mass. A heavy panel changes the effective moving mass of the deck. We ask for the screen's stroke and speed so the section is specified against the machine's actual motion, not against a rule of thumb.
Where it runs
High-tonnage sizing decks in aggregate and quarry plants, coal preparation screens, iron ore and bauxite sizing, and any deck where the limitation is bed depth rather than the cut point.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck dimensions, target tonnage, bed depth if known, stroke and speed, and the finished product specification. We will propose an aperture layout by deck section rather than a single aperture across the whole deck.