Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Recycling Screen Panel in Polyurethane for Construction and Demolition Material
Construction and demolition feed is the least uniform material in any plant. One load is crushed concrete, the next is brick with mortar, the next is soil with rebar in it. Panels on a C&D deck do not wear out evenly — they get torn, hooked and pried by things that were never meant to reach a screen deck.
Tear strength over hardness. Rebar and wire do not abrade a panel, they catch on an aperture edge and pull. A compound at or above 80 kN/m tear strength resists that pull; a hard but brittle compound cracks at the land instead. This is the one duty where tear strength matters more than abrasion figure.
Frame stops the panel being pried loose. Long wire and rebar catch under a panel edge and lever it up. A steel frame distributes that load across the panel rather than into one fixing, so the panel stays seated instead of lifting and letting oversize into the fines.
Soil sheds instead of packing. C&D feed often carries clay and soil with just enough moisture to pack into apertures. Tapered slots combined with panel flex release that material on the return stroke, so the deck does not carry a clay layer into the second section.
Dust and fines do not seize the fixing. Dry recycling duty generates fines that work into every gap. Pin and sleeve fixings with a moulded sleeve keep the seating face clean, so panels come out at change-out rather than having to be cut free.
Where it runs
C&D recycling plants, concrete crushing and rebar separation, asphalt recycling, skip and transfer station material, and mobile crushers working demolition sites.
Technical data
|
Item |
Specification |
|---|---|
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck drawing, aperture, feed mix and the oversize you are trying to remove. If rebar is a known problem, say so — it changes the land width and the panel section we recommend.