Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Perforated Plate Screen Replacement in Polyurethane, Same Fixing Points
Perforated steel plate screens work, and they have worked for a hundred years. They also weigh three times what a polyurethane panel weighs, they crack at the welds where they meet the frame, and they turn a screening deck into the loudest place on the plant. Most plants that still run plate are running it because it is what the machine came with.
Same fixing geometry, different material. Panels are cut and moulded to the plate outline and fixing centres, so the deck frame does not change. No welding, no adapter rails, no re-drilling — the plate comes off and the panel goes on.
A fraction of the mass. This is the change operators notice first. Lower panel mass means lower dynamic load on the screen frame and bearings, and it means a deck that can be inspected by one person instead of a crane.
No welds to crack. Plate fails at the weld or at the bolt hole, because a rigid steel sheet on a vibrating frame has nowhere to put the movement. Polyurethane flexes, and the frame inside the panel carries the structural load without a welded connection to the deck.
Quieter by a wide margin. Steel plate radiates noise; polyurethane damps it. On a plant with a noise boundary or a township nearby, this is sometimes the reason the change gets approved on its own.
Where it runs
Decks currently running perforated plate in aggregate, coal, mineral processing and dewatering service, particularly where noise, weight or weld cracking is the reason for looking at alternatives.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send the plate drawing or a measured outline with hole pattern, thickness and fixing centres. If the plate is dished or worn, measure at the frame rather than on the plate itself.