Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Bauxite Screen Panel in Polyurethane for Wet, Alkaline and Abrasive Duty
Bauxite is a difficult screening material for three reasons at once. It is abrasive, it is often wet and sticky with a clay fraction, and in alumina refineries it arrives in alkaline slurry that attacks the wrong elastomer. A panel that handles two of those three will still fail on the third.
Alkaline resistance in the compound. Caustic conditions rule out a number of general-purpose elastomers. The compound specified for this duty is a hydrolysis-resistant wear grade that holds its properties in alkaline slurry, so the panel does not soften or lose its moulded aperture over a campaign.
Sticky red mud released, not packed. Bauxite with a clay or mud fraction packs into apertures that have straight walls. Tapered slots open through the panel thickness and the panel flexes under vibration, so the material releases on the return stroke instead of being carried down the deck.
Abrasion and impact in one section. Bauxite arrives in lumps at the feed end and as slurry in the washing section. A 40 mm frame section at the feed and 25–30 mm downstream covers both without running a heavy panel across the whole deck.
Frame holds the aperture layout. On a wet deck the panel is under constant load and constant water. A steel frame keeps the panel flat so the aperture geometry stays where it was moulded, rather than taking a set over the support rails.
Where it runs
Bauxite washing and sizing, alumina refinery feed preparation, red mud and residue handling, and bauxite export terminals where wet material is screened before loading.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send slurry pH, temperature, solids content, cut point and deck drawing. Where the duty is alkaline we will confirm the compound against your pH and temperature range before quoting, rather than after.