Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Wire cloth is cheap to buy and expensive to run. It wears at the crown of each wire until strands break, the broken ends end up in the product, and the panel has to come off before it was ever worn out. On a plant with a metal detection or product purity requirement, that is not a maintenance cost — it is a quality incident waiting to happen.
The aperture is moulded through the panel, not woven. There is nothing to fray, nothing to shed into the product, and no loose strand that turns a routine inspection into a contamination investigation.
Wire cloth has to be re-tensioned on a schedule, and a slack panel both blinds and wears faster at the support rails. Polyurethane holds its seated position under a pin and sleeve fixing, so re-tensioning comes off the maintenance list.
A woven panel wins on open area at fine cut points, and there is no point pretending otherwise. What polyurethane trades away in open area it returns in wear life and in wet duty: a wire panel on damp feed blinds at the wire intersections, while a tapered slot releases material on the return stroke.
Wire cloth rings. On a plant with an exposed screening floor and a noise limit at the boundary, the change is measurable and usually welcome.
Dry and wet sizing decks currently running woven wire in aggregate, coal, mineral processing, fertilizer and industrial minerals, particularly where product contamination, noise or re-tensioning downtime is the reason for the change.
| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | Custom cut to your deck drawing |
| Aperture | 3–100 mm, slotted or square; tapered option |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Pin and sleeve, bolt-through, or rail clamp |
Send the mesh specification you run now — aperture, wire diameter, panel outline and fixing centres — plus the cut point and whether the duty is wet or dry. We match the cut and quote the equivalent panel with the same fixing geometry.