Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Foundry Sand Screen Panel in Polyurethane for Sand Reclamation and Refractories
Foundry sand is screened to a purpose, not just to a size. Reclaimed sand has to come back at a controlled grain size and distribution, because the mould strength and surface finish of the casting depend on it. Refractory raw material is graded by fraction, and each fraction goes into a different product. A deck that drifts out of tolerance does not just make a bad batch — it makes a batch nobody can trace the cause of.
Lumps from the shakeout break up and pass. Reclaimed sand carries resin-bound lumps, core butts and occasional metal flash. The tapered aperture lets soft agglomerates break at the surface and pass rather than sitting on the deck and blinding it, which is what a square-hole panel tends to do on this material.
No metal contamination in the sand. Sand going back into a moulding line cannot carry wire fragments. A moulded polyurethane panel has no woven wire to shed, so broken strand contamination is eliminated at the source rather than being caught downstream.
Aperture stability that holds the grain distribution. Foundry sand specifications are written around a distribution, not a single cut. A slot that wears open shifts the distribution coarser over a campaign, and the effect shows up in casting finish before anyone checks the screen.
Temperature has to be respected. Sand leaving a shakeout can be hot. Continuous service on this panel family is rated to +80 °C, so reclaimed sand must be cooled before the deck. If your sand arrives above that, tell us — we will say so rather than sell you something that will fail.
Where it runs
Foundry sand reclamation plants, shakeout and return sand screening, resin and green sand systems, refractory raw material grading, and ceramic and investment casting material sizing.
Technical data
| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | Custom cut to your deck drawing |
| Aperture | 3–100 mm, slotted or square; tapered option |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send sand type, binder system, cut point, sand temperature at the deck and tonnage. For refractory grading, send the fraction sizes — the number of fractions usually decides whether one deck can do the work or whether the layout needs splitting.