Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Slag is one of the least forgiving materials a screen deck will ever see. Bulk density runs well above natural aggregate, the particles are angular and hard, and the stream carries tramp metal that would permanently dent or tear a rigid panel. Add the fact that most slag lines run continuously against a processing schedule, and the deck becomes the thing that decides whether the plant makes its monthly tonnage.
Survives tramp metal. This is where polyurethane earns its place on a slag line. A steel punch plate takes a permanent dent from a piece of skull or a broken bucket tooth; a wedge wire panel bends and stays bent. Polyurethane deflects and returns, so the panel keeps working after an event that would have taken a rigid panel out of service.
Rebound resilience against angular, dense feed. Wear on this duty is not sliding abrasion alone — it is repeated impact by heavy, sharp particles. A compound with rebound resilience at or above 40 % absorbs that energy and returns it rather than cutting, which is why wear life on slag is noticeably longer than on rubber at the same section.
Thickness where the drop is. Slag is usually fed onto the deck from a conveyor at height. We specify 40 mm at the impact zone with wide lands, then step down to 25–30 mm through the middle and discharge where the bed is thinner and the load is sliding.
Stable aperture through a long campaign. Slag products are sold to specification for road base, cement additive or backfill. A slot that wears open changes the gradation, and the change is usually discovered by the customer rather than by the plant.
Where it runsBOF and EAF slag processing lines, ladle and furnace slag sizing, slag crushing circuit screens, and classification into road base, aggregate and cement raw material fractions.
Technical data| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | Custom cut to your deck drawing |
| Aperture | 3–100 mm, slotted or square; tapered option |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Pin and sleeve, bolt-through, or rail clamp |
Send slag type, bulk density, feed size, drop height onto the deck, cut point and whether the stream is wet or dry. Drop height and tramp metal content are the two things that decide section thickness more than anything else.