Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
500mm Hydrocyclone Wear Resistant Underflow Spigot PU Liner Tailings Dewatering Unit
The apex of a tailings cyclone is the hardest working part of the machine. Coarse, high-solids underflow accelerates through the smallest opening in the unit, and on a large diameter body that opening is under constant attack. This 500 mm dewatering cyclone is built with that single point in mind.
| Spigot Construction | Thick-walled cast polyurethane, reinforced seat ring |
| Spigot Options | PU standard, ceramic lined for high silica duty |
| Replacement | Unbolt the spigot ring, fit the new spigot, refit; no cutting or bonding |
| Bore Sizes | 65 / 80 / 100 / 120 mm to set the underflow density |
Because the spigot is a separate, replaceable part with a machined seat, the body does not have to be re-lined when the apex wears. Changing the bore to correct underflow density is a spanner job, not a workshop job.
The cone and cylindrical section are lined with a single cast polyurethane body. No seam sits near the apex, so the wear pattern stays even up to the point where the slurry leaves the unit, and the internal profile that the dewatering performance depends on stays true.
Tailings circuits run 24 hours in process water. Polyurethane does not absorb water or hydrolyse the way some rubber compounds do, so hardness and rebound stay steady through long immersion, and the liner works in chloride bearing water at pH 2 - 13 without a protective coating.
The unit is light for its diameter, so a two-person crew can handle it on a dewatering frame. Apex, vortex finder and liner are all field replaceable, and a complete spares kit is available with the order. All units are produced under ISO 9001, ISO 14001 and ISO 45001 certified systems.
| Liner Type | One-piece hot cast polyurethane (PU) liner |
| Liner Hardness | 88 - 92 Shore A |
| Housing Material | Carbon steel with anti-corrosion coating, SS304 optional |
| Feed Pressure | 0.06 - 0.25 MPa |
| Separation Range | 10 - 150 µm |
| Classification Efficiency | ≥ 85% |
| Underflow Spigot | Replaceable PU spigot, ceramic option |
| Overflow Vortex Finder | Replaceable PU vortex finder |
| Hydrolysis Resistance | ≥ 85% tensile retention after 168 h immersion at 70 ℃ |
| Corrosion Resistance | pH 2 - 13 slurry with chloride bearing water |
| Process Connection | Bolt-on flange / quick clamp, DN50 - DN200 |
| Spare Parts Kit | Apex spigot, vortex finder, inner liner, feed chamber, gaskets |
Mine and quarry tailings thickening, sand plant waste dewatering, coal slime recovery and construction slurry handling where underflow density has to stay consistent.
Send your solids feed rate and required underflow density and we will confirm the spigot bore and vortex finder for your unit.