Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Sand Washing Dewatering Panel in Polyurethane for Drier Product and Cleaner Water
Sand leaving a wash plant wet is a cost in four places at once: water that has to be replaced, weight that has to be trucked, a stockpile that drains into the yard, and a belt that slips on the incline. None of those show up as a screen problem, and all four are solved on the dewatering deck.
Drain the water early, not at the end. The first section of a dewatering deck should carry a slightly coarser slot than the last, so the bulk water leaves immediately and the remaining length works on the film rather than on the flow. That single layout choice typically changes the product moisture more than changing the slot size does.
Slots sized to the product, not to the water. A sand plant that loses fines through the deck is producing a product that does not meet gradation. Slots are specified against the lower size limit of the saleable product, with the taper doing the anti-blinding work.
Surface that lets go of water. Polyurethane has a lower affinity for water than rubber, so the film drains off the panel rather than hanging on it. On a deck that is otherwise correctly set up, this is where the last percentage point of moisture comes from.
Light panels, quick change. Wash plant decks are changed by hand, often between shifts. Reduced panel mass and pin fixing mean a panel can be swapped by one fitter, without a crane and without a shutdown.
Where it runs
Sand washing and classifying decks, manufactured sand plants, silica and glass sand production, and dewatering ahead of stockpiling or loading.
Technical data
|
Item |
Specification |
|
Thickness |
40mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send product gradation, target moisture, tonnage, deck dimensions and screen motion. If fines loss is a concern, send the current underflow gradation so we can see what is passing the deck.
FAQ
What is your MOQ and lead time?
MOQ is 10 pcs. Standard lead time is 15 days, and standard mold making takes 10 days.
Can I reduce product moisture without changing the screen?
Partly — deck angle, feed rate and water addition all matter. But if the slots are blinded, no amount of adjustment will help until the panel is changed.
Will a finer slot give a drier product?
Not necessarily. A finer slot drains slower and blinds more readily. On most sand duties the drier product comes from a correct slot plus a thinner bed, not from the smallest slot available.