Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Lightweight Polyurethane Dewatering Screen Panel Custom Fit for One Man Panel Changes
Panel changes happen in the gap between shifts, in a wet sump, with whatever labour is on site. That is the real constraint on a dewatering deck, and it is rarely the number on the datasheet. A panel that one man can lift and pin in place gets changed on time; a panel that needs a crane or a second fitter gets run until it fails.
Mass kept down deliberately. The panel is moulded at 40mm in a compound that carries the wear without adding dead weight, so a standard 1044mm x 702mm panel is manageable by one person on the deck. No lifting frame, no crane booking, no waiting for the next shutdown.
Pin fixing instead of bolted rails. Panels locate on existing pins and are held by a sleeve, so the change is a lift and a pin rather than a torque sequence. Bolt-through and rail clamp versions are available where the deck is already set up that way.
Custom fit to the frame you have. The outline, the pin hole positions and any cut-outs are made to your deck drawing, so a replacement panel drops onto the existing pins without frame drilling or adapter strips. That keeps the change inside the maintenance window.
Single panels can be replaced, not whole decks. Because each panel is individually fixed, a worn or blinded panel comes out on its own. There is no need to strip a full deck to deal with one failed section, which is the usual reason decks are run past the point where they should have been changed.
Where it runs
Wash plant and sand plant dewatering decks changed by hand, mobile and modular plants where maintenance access is tight, coal preparation decks worked in short shutdowns, and any site where panel handling labour is the limiting factor.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
1044 mm x 702 mm standard; custom cut to your deck drawing |
|
Aperture |
0.1–100 mm slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Customisation
Panel outline, pin hole diameter and hole positions are taken from your deck drawing, so the replacement goes onto the existing pins. Where a deck is changed by hand, thickness and cut-outs can be adjusted to keep the panel within a weight one fitter can lift on the deck.
Ordering
Send the deck drawing with pin hole positions, the number of panels per deck and how the panels are currently fixed. If the deck is being changed by hand today, tell us the current panel mass and we will confirm what the replacement weighs.
FAQ
How much does one panel weigh?
A 40mm panel at 1044mm x 702mm is light enough for one fitter to handle on the deck. The exact figure is confirmed on the drawing, since cut-outs and thickness change it.
Can I change one panel without removing its neighbours?
Yes. Panels are individually pinned, so a single panel can be released and lifted out on its own.
Will the new panels fit the old pin centres?
They are made to your drawing, so the hole positions are taken from the deck as it is. Send the pin spacing with the order.