Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Coal Slurry Dewatering Panel in Polyurethane for Fine Coal and Tailings
Moisture in saleable coal is priced. Every percentage point above the contract figure is either a penalty or free water you are trucking to a customer. In a washing plant, most of that moisture is decided on the fine coal dewatering deck, not in the centrifuge.
Deck geometry matters more than slot size. On fine coal, water leaves through the first section and the last section polishes the surface film. A deck with a consistent slot across its full length works against that. Slots are specified by section so the drainage front stays where it belongs.
Tapered slots resist the blinding that fine coal causes. Fine coal at 0.5 mm sits exactly on the boundary that pegs. A tapered slot releases on the return stroke, which is what keeps the discharge end draining through a full shift rather than sealing over by mid-shift.
Abrasion resistance for magnetite circuits. Where the dewatering deck also handles correct medium, wear is abrasive rather than sliding. A compound at or below 40 mm³ DIN abrasion keeps the slot dimension stable, which is what protects magnetite consumption.
Panel mass matched to the drive. Fine coal decks run at high frequency. A light section lets the machine deliver its design acceleration, which is the variable that actually moves water out of a fine coal bed. At 40 mm on the feed and 25 mm downstream, the deck carries its design stroke instead of being limited by panel weight.
Where it runs
Fine coal dewatering and tailings dewatering, correct medium recovery, desliming screens and product dewatering ahead of stockpile or loadout.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send feed ash, solids content, target moisture, slot size currently in use and deck dimensions. If magnetite consumption is a concern, tell us — it usually points at slot wear rather than at the medium itself.