Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
A filter is an expensive way to remove water. Every tonne of water you send to it costs filter area, cycle time and flocculant, and it comes back as cake moisture you then pay to dry or to ship. A dewatering screen ahead of the filter is not a competing technology — it is the cheapest stage in the whole dewatering chain.
Thickening the feed before it reaches the filter. A dewatering deck takes dilute concentrate to a handleable pulp, and that reduction in water load translates directly into filter capacity. On an existing filter installation this is often the lowest-cost way to raise throughput without buying another unit.
Slots that hold the solids, not the water. On concentrate duty the value is in the solids, so fines loss through the deck is a direct recovery loss. Slots are specified against the fine end of the concentrate gradation, and the taper keeps them open under a bed that is dense and fast-settling.
Abrasion resistance for dense, sharp solids. Concentrate is heavy and often angular. Wear concentrates on the lands and at the feed point, which is where a thick section at the feed and a thinner one downstream earns its cost.
Stable geometry under continuous load. A deck running 24 hours on dense pulp deflects constantly. A frame or a thick section keeps the panel flat so the drainage path stays consistent from one end of the campaign to the other.
Concentrate dewatering ahead of disc, drum and pressure filters in copper, lead-zinc, iron and gold circuits, plus middlings and smelter feed preparation.
Technical data| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | Custom cut to your deck drawing |
| Aperture | 3–100 mm, slotted or square; tapered option |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Pin and sleeve, bolt-through, or rail clamp |
Send concentrate gradation, feed solids content, tonnage to the filter, deck dimensions and screen motion. We will size the slot against solids retention rather than against drainage speed alone.