Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Pre-Dewatering Screen Panel in Polyurethane for Drain and Rinse Sections
Most dewatering problems are created before the dewatering deck. If free water arrives at the drain-and-rinse section still in the pulp, the deck spends its length moving water instead of draining the bed, and the medium or the product leaves wet no matter what aperture is fitted.
Free water removed at the first opportunity. A pre-dewatering section ahead of a sieve bend or a main drain deck takes the bulk water off while the material still has enough velocity to keep a thin bed. Panels for this position are specified with a relatively open slot and a short land, because the objective is flow, not retention.
Deck angle is part of the specification. A pre-dewatering deck runs at a shallow angle so the material moves as a thin film rather than a rolling bed. Aperture and land width are chosen against that angle; a panel designed for a horizontal deck will not perform the same way at 5°.
Slots that do not blind on the first pass. Pre-dewatering feed is dilute and fast, which is the condition where a slot blinds fastest as velocities drop at the discharge end. Tapered slots keep that last section working.
Wear resistance at the feed point. Pre-dewatering sections take the full velocity of the slurry, and wear is concentrated in the first 300 mm. A heavier section at the feed and standard section downstream is the pattern that gives the best life per dollar.
Where it runs
Ahead of sieve bends in coal and mineral circuits, upstream of drain-and-rinse decks in dense medium plants, ahead of fine screens on sand plants, and on any deck where free water has to leave before the material reaches the working section.
Technical data
|
Item |
Specification |
|
Thickness |
40 mm standard; 25–60 mm on request |
|
Panel size |
Custom cut to your deck drawing |
|
Aperture |
3–100 mm, slotted or square; tapered option |
|
Hardness |
Shore A 85 (75–95 available) |
|
Compound |
Hydrolysis-resistant wear grade polyurethane |
|
Density |
1.10–1.15 g/cm³ |
|
Tensile strength |
≥ 30 MPa |
|
Tear strength |
≥ 80 kN/m |
|
Abrasion (DIN 53516) |
≤ 40 mm³ |
|
Rebound resilience |
≥ 40 % |
|
Service temperature |
−30 °C to +80 °C |
|
Fixing |
Pin and sleeve, bolt-through, or rail clamp |
Ordering
Send deck angle, feed solids content, tonnage, slot size in the working section and deck drawing. Tell us whether the panel sits ahead of a sieve bend or replaces a drain section — the two positions are specified differently.