Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Bucket Wheel Sand Washer Screen in Polyurethane, Fitted Per Bucket
A bucket wheel washer dewater-ises by lifting, and the panel inside each bucket is what determines how much water leaves before the material is tipped. It is a short working stroke, a lot of repetition, and no opportunity to adjust anything once the wheel is turning. Which means the replacement insert either fits correctly and drains correctly, or it does not, and you find out in the first hour.
Made to the bucket, not to a catalogue. Wheel builders rarely share a standard layout, and even two machines from the same maker can differ. Panel outline, bolt pattern and curvature are taken from your drawing or from a measured sample, so the insert seats against the bucket face rather than standing proud of it.
Individual buckets are replaceable. Because panels are made per bucket, damage is local and the fix is local too. One worn or cracked insert comes off and goes back on without disturbing the rest of the wheel, which is a job measured in minutes rather than a shift.
Slot held to ±0.03 mm. Fine sand leaving through a slot that has worn open 0.1 mm is product you are pumping into your settling pond. Slots are moulded from a machined tool, so the width you specified is the width the wheel runs at, across every insert, for the life of the panel.
Flexes instead of cracking. Each bucket loads and unloads thousands of times a day. Polyurethane takes that cyclic load without work-hardening at the bolt holes, which is where a rigid insert starts to fail.
Where it runs
Bucket wheel sand washers and washer-classifiers in aggregate, quarry and manufactured sand plants, including machines working gravel-pit feed with a variable fines fraction.
Technical data
| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | 500 x 550 mm standard; custom cut to your drawing |
| Slot width | 0.1–4.0 mm slotted; tapered option |
| Slot tolerance | ±0.03 mm on slot width |
| Open area | 20–38 % depending on slot width |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Bolt-through, pin and sleeve, or rail clamp |
Ordering
Send the wheel diameter, bucket count, one bucket drawing or a measured sample insert, and the slot width currently in service. A worn sample is often enough — we can measure from the part rather than waiting for drawings.