Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Manufactured Sand Washing Panel in Polyurethane for Fines Control
Manufactured sand has a problem natural sand does not: the fines are not fines, they are crusher dust. They carry the methylene blue value up, they raise water demand in concrete, and they make the product difficult to sell. Removing them is the job of the wash — but washing aggressively also strips the -0.6 mm fraction that gives manufactured sand its workability.
The panel is where that balance is decided.
Slot chosen at the fines boundary. There is a specific point, set by your target MB value and your acceptable fines content, below which material must go and above which it must stay. The slot is specified against that boundary rather than against what the plant has historically used.
Retains the fraction that matters. Manufactured sand without its fine fraction is a coarse, harsh product that bleeds and is unpleasant to place. A tapered slot at 0.2–0.5 mm removes the dust while keeping the sand particles, which is a different separation from simply washing harder and losing both.
Consistent across the whole deck. Tolerances of ±0.03 mm mean every panel separates at the same size, so the product leaving the plant does not change because one section happens to be more open than another.
Dry mining makes the duty harsher. Dry-process plants feed crushers that produce sharp, angular grains with high residual dust load. Abrasion resistance at ≤40 mm³ DIN is what keeps the land width — and therefore the slot geometry — stable through a campaign.
Where it runs
Manufactured and crushed sand washing lines, dry-process aggregate plants adding a wash stage, VSI circuit product finishing, and concrete sand production where fines content is contractually limited.
Technical data
| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | 500 x 550 mm standard; custom cut to your drawing |
| Slot width | 0.1–4.0 mm slotted; tapered option |
| Slot tolerance | ±0.03 mm on slot width |
| Open area | 20–38 % depending on slot width |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Bolt-through, pin and sleeve, or rail clamp |
Ordering
Send feed gradation, crushing stages and product class (I / II / III if you are working to a national standard), plus the target fines and MB figures. Panel specification follows from those targets, not from the machine size.