Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
A screw washer is deceptively hard on its internals. The tub carries wet, sharp material continuously, the flights push it against anything bolted to the shell, and the whole assembly sits submerged for most of the day. Steel liners wear thin and start to perforate, and once a tub starts leaking slurry nobody wants the repair job.
Two parts, specified together. Wear is not distributed evenly in a screw tub. The bottom of the trough takes sliding abrasion from sharp sand, while the drainage and discharge sections need aperture rather than protection. We specify liner panels and screen panels as one set against your tub drawing, so each section does the job it actually has.
Material cost of sliding abrasion. A compound at or below 40 mm³ DIN abrasion is what holds the liner thickness over a season; hardness alone will not do it, because a hard compound that cannot recover will crack where the flight passes.
Bolt-in modules, replaced in sections. Panels bolt down individually rather than being bonded in place. A worn bottom section comes out without stripping the tub, and no hot work is needed inside the machine.
Drainage section holds the slot. Where the tub transitions to drainage, the slot decides how much fine sand goes with the water. Slots are moulded rather than cut, so that section keeps working at the width it was specified at instead of opening up gradually.
Single and twin screw sand washers, coarse material washers, log washer drainage sections and scrubber tubs in aggregate and mineral sands plants.
| Item | Specification |
|---|---|
| Thickness | 40 mm standard; 25–60 mm on request |
| Panel size | 500 x 550 mm standard; custom cut to your drawing |
| Slot width | 0.1–4.0 mm slotted; tapered option |
| Slot tolerance | ±0.03 mm on slot width |
| Open area | 20–38 % depending on slot width |
| Hardness | Shore A 85 (75–95 available) |
| Compound | Hydrolysis-resistant wear grade polyurethane |
| Density | 1.10–1.15 g/cm³ |
| Tensile strength | ≥ 30 MPa |
| Tear strength | ≥ 80 kN/m |
| Abrasion (DIN 53516) | ≤ 40 mm³ |
| Rebound resilience | ≥ 40 % |
| Service temperature | −30 °C to +80 °C |
| Fixing | Bolt-through, pin and sleeve, or rail clamp |
Send the tub drawing if you have it, or screw diameter, tub length, flight pitch and the sections that need lining versus drainage. Knowing which parts are wearing out fastest tells us more than the machine model does.