Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
Steel Backed Polyurethane Blind Plate 15mm Wear Resistant Blanking Pad Custom Molded
Where the load is coarse rock rather than slurry, a free standing elastomer plate eventually creeps at the bolt holes. The answer is to cast the polyurethane directly onto a prepared steel backing plate so the two behave as one composite section. The elastomer is chemically bonded during cure, not glued afterwards, and the steel carries the bolt load while the PU absorbs the impact.
The backing plate is grit blasted, primed with a bonding agent and located in the mould before pouring. Because the bond forms while the elastomer is still reactive, pull-off strength stays stable across the service temperature range instead of degrading at the first hot campaign.
Standard elastomer thickness is 15 mm on a 6 mm or 8 mm backing plate, giving an overall section of 21 to 23 mm. Backing plate outline, hole pattern, lifting eyes and edge return can all be produced to your drawing. Hardness is normally 90 Shore A for this duty, and 95 Shore A is available for the most aggressive positions.
Each unit is checked for bond integrity by visual and tap test across the full face, and overall thickness is measured at nine points. Records are kept against the batch number printed on the backing plate.
| Material | Cast polyurethane elastomer, MDI pre-polymer system |
| Hardness | 85 +/- 3 Shore A (80A / 90A / 95A on request) |
| Thickness | 10 / 15 / 20 / 25 / 30 mm |
| Plate Size | 1000 x 1000 mm standard, custom up to 2000 x 1200 mm |
| Dimensional Tolerance | +/- 1.0 mm length and width, +/- 0.5 mm thickness |
| Tensile Strength | Not less than 45 MPa |
| Tear Strength | Not less than 90 kN/m |
| Abrasion Loss | Not more than 60 mm3, DIN 53516 |
| Density | 1.10 - 1.15 g/cm3 |
| Service Temperature | -30 C to +80 C |
| Colour | Natural amber, black or matched to sample |
| Fixing Method | Bolt-through, countersunk insert or steel backed |
| Certification | ISO 9001, ISO 14001, ISO 45001 |
Face protected by a removable film, units separated by foam, crated in plywood with steel strapping and lifting marks.