Quick Link
Quick Contact
Address
No.367 Beijing Road, Longquanyi District, Chengdu, China
Tel
86--13981727059
Our Newsletter
Subscribe to our newsletter for discounts and more.
OEM Custom Molded Polyurethane Blind Plate 12mm Abrasion Resistant Trommel Deck Cover
Scrubbers and trommels are hard on deck covers: the load tumbles, the water is dirty and the plate is usually curved or profiled rather than flat. This 12 mm blind plate is produced from an OEM drawing or from a sample that is measured and reverse engineered, so the finished cover follows the drum radius and the existing fixing strap positions.
Curved covers are cast in a machined aluminium or steel mould with the radius built in, which avoids the spring-back you get when a flat sheet is bent cold. Ribs, drainage grooves, strap recesses and locating bosses are all formed in the mould rather than cut later, so the geometry stays consistent from the first unit to the five hundredth.
The 12 mm section is intended for covers supported by a drum shell or strap frame. For unsupported spans the thickness is increased to 15 or 20 mm. Standard grade is 85 Shore A with a high abrasion resistant package for slurry with sharp sand; 90 Shore A is used where the cover also takes direct impact from the feed chute.
New moulds are typically 12 to 15 working days. Once tooling exists, repeat covers are cast against the existing pattern, and drawings are held on file so a replacement can be run without re-measuring on site.
| Material | Cast polyurethane elastomer, MDI pre-polymer system |
| Hardness | 85 +/- 3 Shore A (80A / 90A / 95A on request) |
| Thickness | 10 / 15 / 20 / 25 / 30 mm |
| Plate Size | 1000 x 1000 mm standard, custom up to 2000 x 1200 mm |
| Dimensional Tolerance | +/- 1.0 mm length and width, +/- 0.5 mm thickness |
| Tensile Strength | Not less than 45 MPa |
| Tear Strength | Not less than 90 kN/m |
| Abrasion Loss | Not more than 60 mm3, DIN 53516 |
| Density | 1.10 - 1.15 g/cm3 |
| Service Temperature | -30 C to +80 C |
| Colour | Natural amber, black or matched to sample |
| Fixing Method | Bolt-through, countersunk insert or steel backed |
| Certification | ISO 9001, ISO 14001, ISO 45001 |
Covers are crated on edge in plywood cases with foam separators, steel strapped, and marked with part number and batch.